4836IC
Intermediate Care Shower Stall with Built-In Seat with full blocking & optional Stainless Steel Grab Bars
| Length | 47 3⁄4" | 1213mm |
| Width | 35 3⁄4" | 908mm |
Download Spec Sheet
Shower unit shall be a VENCO Model No. 4836IC. With a Built-in RH/LH Seat and Soap Holder. Finished surface shall be a Premium sanitary-grade polyester Gelcoat with a minimal thickness of 15 dry mills and a finished cured Barcol hardness of 80-90. The unit shall have dimensions of 47 3⁄4" x 35 3⁄4" x 79 1⁄2" O.D. Sides and back of unit shall be constructed of molded reinforced fiberglass with 15% minimum fiberglass content. Plus an inner core of 7/16" Wafer board, minimum 7" wide, installed on the two walls opposite the built-in seat. This will be centered at 35" above finished floor for the installation of "L" shaped 1 1⁄4" Stainless Steel Grab Bar.
The unit is laminated with another layer of reinforced fiberglass for superior overall rigidity. The approximate weight of the unit shall be 168 lbs. The base of the unit shall be attached to form an integral part. The height of the Soap Holder from the finished floor is approx. 35 1/5". The height of the Seat from the finished floor is approx. 16".C.S.A. Approved. The door opening is 45 3⁄4" wide x 71" high.
Click images below to view additional images
Warranty is to the original purchaser only, that this unit is free from manufacturing defects in material or workmanship for a period of five (5) years from date of installation. The Addition of grab bars or fixtures not properly installed by purchaser shall void this warranty.
